Do you have a licence for Mach?

all good now
 took the tick out of use spindle feedback in sync modes box

not all good now the thread looks bad .
the mach3 threading pdf said it needs the spindle feedback in sync modes boxed checked.
is this correct?
are there any other configuration settings that need to be input
thanks

chessie,

You are using an external motion device and should have said so right from the get go.

Have no experience with the UC400 ETH controller. There should be a installation
and user guide available for use with Mach from the seller / manufacturer. There are product downloads available
for the 400. Did you have a read of that info?

If someone has experience with  UC400 ETH they can help you and may reply
here. If not,  I would suggest that you go back to the manufacturer for  specifics.

The mach3 threading pdf does not address the UC400 ETH.


RICH

As Rich has said you need to ask any questions you have regarding threading on the CNC Drive forum http://forum.cncdrive.com/viewforum.php?f=22

Tweakie.

Gee guys I tried to answer the question. (;-)

(;-) TP

OK thanks what do u have to do or buy to fix this please

Gee guys I tried to answer the question. (;-)

(;-) TP

Sorry TP (I missed your posting).

Tweakie.

I see the user has made an inquiry over at the UCCNC forum. Lets see where that leads to as far as an answer.

(;-) TP

are you saying this wont work with a disc and proximity sensor connected to index ?
If not do you have a solution
cheers