Hello Guest it is March 28, 2024, 04:34:49 PM

Author Topic: Ethernet Smooth Stepper with THC  (Read 933 times)

0 Members and 1 Guest are viewing this topic.

Ethernet Smooth Stepper with THC
« on: August 04, 2019, 04:38:02 PM »
Hello,

I've searched this forum and other forums on the internet but I can't seem to find the answer.

I want to use THC with ESS and Mach3. I've got a signal (the up and down leds are moving). THC is on and the curr value is changing to the min and max setpoint. Unfortunately the Z-axis doesn't move with the changes the proma thc makes to the curr value. When I click 'go to zero' the z-axis moves to the curr value set by the THC. So everything works but the z movements are not "live/active". Does anyone know what I did wrong?

Paul van Hoek

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Ethernet Smooth Stepper with THC
« Reply #1 on: August 05, 2019, 01:06:06 AM »
do you have the Torch On Signal wired and working?
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Ethernet Smooth Stepper with THC
« Reply #2 on: August 05, 2019, 04:05:08 PM »
Yes, wired and checked. The torch on light turn on when the torch ignites or when I run the test mode on the proma thc.