Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: paulvanhoek on August 04, 2019, 04:38:02 PM
-
Hello,
I've searched this forum and other forums on the internet but I can't seem to find the answer.
I want to use THC with ESS and Mach3. I've got a signal (the up and down leds are moving). THC is on and the curr value is changing to the min and max setpoint. Unfortunately the Z-axis doesn't move with the changes the proma thc makes to the curr value. When I click 'go to zero' the z-axis moves to the curr value set by the THC. So everything works but the z movements are not "live/active". Does anyone know what I did wrong?
Paul van Hoek
-
do you have the Torch On Signal wired and working?
-
Yes, wired and checked. The torch on light turn on when the torch ignites or when I run the test mode on the proma thc.