Hi,
I have a NVEM V2 ethernet controller
Maybe I have to configure Mach3 differently with these commands ?
No, unfortunately that controller does not support those commands, there is no workaround or manipulation you can
do in Mach3 that will make that controller support those commands. It is a known and recurring issue that Chinese controllers
that, at best, support a subset of Mach commands, in this case not including M10, M11.
You either revert to a parallel port, assuming you have a Windows 7 or earlier 32bit PC or get a decent US or European
motion controller like an Ethernet SmoothStepper, a UC300 or a 57CNC.
Craig