Hello All,
I am experimenting with the latest build of the Mach4 Plasma profile and using a Pokeys 57E analog input card to read in the divided arc voltage (I am using a variable DC source for testing, not the torch voltage). I have set the Plasma config to the correct register and it changes with the voltage input, but I cant figure out how to relate this to an arc voltage on the THC screen.
-We are using Mach4 build 4225 for reference
-Is there a scaling factor somewhere in the Mach4 config?
-In Pokeys, the analog value is 0-4095, which equates to 0-3.3 volts. Once you connect Pokeys to Mach via the plugin, the Pokeys diagnostic screen shows a value of 0-1 with no units in the register.
-If you copy the Pokeys register to the clipboard and paste it into the THC config screen for the register used, when you go back to THC diagnostic the iRegs0/nf/thc/ThcActualVoltage register only reads the default 120 value, same as before changing the register.
Any help is appreciated.
Thanks,
Jamie