Hello Guest it is March 28, 2024, 01:40:49 PM

Author Topic: Turn tool-path display oddities...  (Read 1937 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Turn tool-path display oddities...
« Reply #10 on: June 01, 2019, 12:15:25 PM »
I can't be 100% certain as it must be over 10 years since I set up my lathe initially, I think however they should be ok.

Offline Davek0974

*
  •  2,606 2,606
    • View Profile
Re: Turn tool-path display oddities...
« Reply #11 on: June 01, 2019, 12:23:11 PM »
Ok thanks, i'll flip them and restart tomorrow, see what happens.

While you're there Hood, when adding another tool using the method you outlined, is there any need to reference an existing tool first or just go in, touch Z, take a cut and measure X then set the touch-X DRO and press touch X??

Offline Davek0974

*
  •  2,606 2,606
    • View Profile
Re: Turn tool-path display oddities...
« Reply #12 on: June 01, 2019, 01:21:45 PM »
Ignore that, just answered it myself ;)

Answer was yes BTW )