Motors stalling /growling

Pages: « 1 2 3 4 5 6 7 8 9 10 11 Go Down

0 Members and 2 Guests are viewing this topic.

« Reply #100 on: June 09, 2019, 06:35:41 AM »

When entering the G1 xo.1968 f1, it keeps turning never stops and is very slow and rough sounding.

have you zeroed x-axis before Input?

Logged

anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.

« Reply #101 on: June 09, 2019, 05:41:32 PM »

no it was not. After zeroing it out, it did make one revolution.

Logged

« Reply #102 on: June 10, 2019, 03:42:42 AM »

ok that means microstepping and steps per are correct.
next step would be to have a look with oszilloscope for the step/dir signals.

Logged

anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.

Pages: « 1 2 3 4 5 6 7 8 9 10 11 Go Up