Hello
Guest
it is
August 31, 2024, 11:44:46 PM
Guest
Login
Register
Menu
Home
Help
Search
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
General Mach Discussion
/
Help in settings...
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: Help in settings... (Read 2932 times)
0 Members and 1 Guest are viewing this topic.
giannis121
145
Help in settings...
«
on:
August 28, 2007, 07:32:06 AM »
I need some help in the seetings of mach3.
While the motors are moving, i can hear a noise like "gap-gap..." given in stable time.
I suppose that the problem is the PC, because i have used another PC and i didn't have these problems.
I have changed the configurations to this PC as
www.machsupport.com
gives (msconfig, etc...).
Has the kernel speed to do with that? What should i look for?
Any advice would be helpfull.
Logged
Brian Barker
3,860
Re: Help in settings...
«
Reply #1 on:
September 04, 2007, 08:24:00 AM »
Hello, Have a look on the downloads page and you will find the optimization guide, in this will will find all the steps needed to get your steps a bit smother..
Logged
Fixing problems one post at a time
www.newfangledsolutions.com
www.machsupport.com
Print
Pages:
1
Go Up
« previous
next »