Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: giannis121 on August 28, 2007, 07:32:06 AM
-
I need some help in the seetings of mach3.
While the motors are moving, i can hear a noise like "gap-gap..." given in stable time.
I suppose that the problem is the PC, because i have used another PC and i didn't have these problems.
I have changed the configurations to this PC as www.machsupport.com gives (msconfig, etc...).
Has the kernel speed to do with that? What should i look for?
Any advice would be helpfull.
-
Hello, Have a look on the downloads page and you will find the optimization guide, in this will will find all the steps needed to get your steps a bit smother..