Hello Guest it is June 19, 2019, 09:39:45 AM

Author Topic: Is there a Gcode command to reference all axis home?  (Read 280 times)

0 Members and 1 Guest are viewing this topic.

Re: Is there a Gcode command to reference all axis home?
« Reply #10 on: March 22, 2019, 10:38:23 AM »
Russ,
Yeah, I have the newest profile from the FTP site on my computer at work, so my manual is updated, didn't even think about it not being in the older manuals.
Chad Byrd

Offline Bill_O

*
  •  220 220
    • View Profile
Re: Is there a Gcode command to reference all axis home?
« Reply #11 on: March 22, 2019, 03:30:45 PM »
My only problem with the G28.1 is the speed is very slow.
I can not find how to change the speed.

Offline MN300

*
  •  91 91
    • View Profile
Re: Is there a Gcode command to reference all axis home?
« Reply #12 on: March 22, 2019, 03:44:02 PM »
You have said the error is small. You could do a high speed move to a location near home before the G28.1 command to speed things up.
Re: Is there a Gcode command to reference all axis home?
« Reply #13 on: March 22, 2019, 03:45:50 PM »
That'w what I was going to suggest. 
It homes as if you clicked the Reference button; command a G53 move close to Axis Zero.
Chad Byrd

Offline smurph

*
  • *
  •  1,094 1,094
  • "That there... that's an RV."
    • View Profile
Re: Is there a Gcode command to reference all axis home?
« Reply #14 on: March 24, 2019, 01:54:53 PM »
The home speed is configured in Homing/Softlimits tab as a percentage of the axis' maximum velocity.  The axis maximum velocity is derived from the slowest of the motors that run the axis (Motors tab).

Steve