Hi,
So My Stupid question is that besides the Warp9 setup configure, do I need to do it All Again in the plug down Control window??
No.....in most cases. When you open the ESS plugin and set an input for instance Machs Control plugin is automatically
updated also.
There are items where that is not the case. Motor tuning settings for example must be set in the Control plugin.
It is quite confusing initially as to what Mach variables are updated when you change them in the ESS plugin. With
the ESS plugin about 90% of the changes which are made there are automatically reflected in the Control plugin.
Other controller manufacturers don't do that, or at least to the same extent. Thus with the UC300 if you wish to
set an input you first make the change in the UC300 plugin and THEN go into the Control plugin and make the change
there also.
Craig