Hello Guest it is September 21, 2019, 10:57:11 PM

Author Topic: Crashing !  (Read 195 times)

0 Members and 1 Guest are viewing this topic.

Crashing !
« on: March 12, 2019, 12:28:28 PM »
Hi Everyone.

OK, I'm new to Mach3. I have a clean 32bit Windows7 machine and have Administrator access. Having downloaded  Mach3 the first few times it crashed but I eventually got it to run, don't know how. I have set all the pins for my 5 Axis Breakout Board and when I restarted back to crashing again :(  After some more  trying I get it going again (don't know how) and run the Driver Test. The Preparation Successful screen come up and then the Take over screen, CRASH ! I tried installing the SpecialDriver but that made no difference, still crash.
 
I did manage to get it working once to the stage where I could manually jog but when connected to my machine it did nothing so I'm guessing the drivers just aren't there. The router does make a few clicking noises as the computer is re-booting so I think they are trying to talk to each other.

The router is all home built following the recipe on YouTube of building a CNC machine for under 900 dollars
The Breakout board is by Savebase.com

Any suggestions would be much appreciated.
Richard

Offline reuelt

*
  •  444 444
    • View Profile
Re: Crashing !
« Reply #1 on: March 12, 2019, 06:58:14 PM »
Go into command prompt with administrator rights and paste and add the below registers.

reg add "HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Session Manager\Memory Management" /v FeatureSettingsOverride /t REG_DWORD /d 3 /f

reg add "HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Session Manager\Memory Management" /v FeatureSettingsOverrideMask /t REG_DWORD /d 3 /f

Restart the computer for the changes to take effect.
"the gift of God is eternal life through Jesus Christ our Lord"
Re: Crashing !
« Reply #2 on: March 14, 2019, 08:27:40 AM »
That's great thanks reuelt.

I now have the machine working, all set up except the jog is very slow. I'll look for a video on it.

Now to find some CAD program that will draw gears among other things that is simple to use :)

Thanks again

Offline Tweakie.CNC

*
  • *
  •  7,911 7,911
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Crashing !
« Reply #3 on: March 14, 2019, 10:45:31 AM »
Quote
Now to find some CAD program that will draw gears among other things that is simple to use

Take a look at Gearotic Motion;  http://www.gearotic.com/
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.