Hello Guest it is March 28, 2024, 06:05:53 AM

Author Topic: Spindle relay on by M3 command  (Read 1185 times)

0 Members and 1 Guest are viewing this topic.

Spindle relay on by M3 command
« on: February 19, 2019, 07:15:07 AM »
Hi ,
I have a TB6560 board and I can control relay (black relay on low right in image atached) with F5 key or with Spindle CW F5 button on Mach3 interface but when I try to put M3 command in my G code nothing happends.
How can I control that relay to work with M3 M5 command?
Thanks

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Spindle relay on by M3 command
« Reply #1 on: February 19, 2019, 09:08:26 AM »
any documentation about this board?
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Retired Master Electrician, Commercial HVAC/R Service and lots of Hobbys.
Re: Spindle relay on by M3 command
« Reply #3 on: February 19, 2019, 04:45:08 PM »
Here all docs I have about this TB6560

Offline ZASto

*
  •  423 423
    • View Profile
Re: Spindle relay on by M3 command
« Reply #4 on: February 20, 2019, 12:53:05 AM »
The problem has nothing to do with TB6560 chip, which is, by the way, crap.
Make no mistake between my personality and my attitude.
My personality is who I am.
My attitude depends on who you are.

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Spindle relay on by M3 command
« Reply #5 on: February 20, 2019, 01:31:46 AM »
ok found some additional Information, where it Looks like relay Output is port1 pin1.

so check:
->Config -> Ports & Pins -> Spindle Setup
    -disable spindle relays is not selected
    -ClockWise (M3) Output# is 2

->Config -> Ports & Pins -> Output Signals
   -Output #2 is enabled
   -Output #2 port is 1
   -Output #2 pin number is 1
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.