Hello Guest it is June 12, 2024, 09:06:32 PM

Author Topic: cutting to small  (Read 890 times)

0 Members and 1 Guest are viewing this topic.

cutting to small
« on: February 16, 2019, 07:25:55 PM »
okies ill start by saying im pretty new this this stuff so be kind :) ive been running mach3 for about a year :o then ran into the port issue, got that resolved but now when i run a image thru mach3 it cuts way to small.. I.E. image is 8"X 10" cuts it like it was 1\8th inX 1/8 in..
Re: cutting to small
« Reply #1 on: February 16, 2019, 07:48:18 PM »
sounds like the machine is cutting in millimeters rather than inches.

Put a G20 at the top of the file and try again.

'I enjoy sex at 73.....I live at 71 so its not too far to walk.'