Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Wirez1976 on February 16, 2019, 07:25:55 PM
-
okies ill start by saying im pretty new this this stuff so be kind :) ive been running mach3 for about a year :o then ran into the port issue, got that resolved but now when i run a image thru mach3 it cuts way to small.. I.E. image is 8"X 10" cuts it like it was 1\8th inX 1/8 in..
-
Hi,
sounds like the machine is cutting in millimeters rather than inches.
Put a G20 at the top of the file and try again.
Craig