Hello Guest it is April 18, 2024, 05:35:41 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: DETERMINATION OF LINEAR LENGTH OF A PLASMA CUT  (Read 868 times)

0 Members and 1 Guest are viewing this topic.

Offline enzed

*
  • 7 7
    • View Profile
DETERMINATION OF LINEAR LENGTH OF A PLASMA CUT
« on: January 31, 2019, 09:14:44 AM »
Is there any way that the total linear length of plasma cutting can be determined by Mach3 for a specific job? Or is this a question for the Sheetcam guys?

enzed
Logged

Offline MyGarageShop

*
  • 37 37
    • View Profile
    • Some of my work
Re: DETERMINATION OF LINEAR LENGTH OF A PLASMA CUT
« Reply #1 on: February 01, 2019, 09:34:29 AM »
I was able to do this in my post processor but I use BobCAD not SheetCAM. I would think if I could do it in BobCAD you can do it in SheetCAM.
Logged
Velox 4 Axis Router, Mach3, Windows 7 32 bit
Modified to also be a Plasma / Engraver
with a Dual Chamber Water Table

Some of my work
https://mygarageshop.com/

ScreenSet: SmartScreens for Mach3
https://ngeneyes.com/smartscreen/licensing/

Offline enzed

*
  • 7 7
    • View Profile
Re: DETERMINATION OF LINEAR LENGTH OF A PLASMA CUT
« Reply #2 on: February 01, 2019, 10:13:42 AM »
Thank you. So it can be done. But I'm unsure how it would be done in the post processor (I guess that you're referring to Mach3?). And I'm impressed with your very nice work.
enzed
Logged
Pages: 1   Go Up
« previous next »