Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: enzed on January 31, 2019, 09:14:44 AM
-
Is there any way that the total linear length of plasma cutting can be determined by Mach3 for a specific job? Or is this a question for the Sheetcam guys?
enzed
-
I was able to do this in my post processor but I use BobCAD not SheetCAM. I would think if I could do it in BobCAD you can do it in SheetCAM.
-
Thank you. So it can be done. But I'm unsure how it would be done in the post processor (I guess that you're referring to Mach3?). And I'm impressed with your very nice work.
enzed