Hi,
I have R2.0.060.
What are the differences/improvements with R2.4?
Heres what the revision history says from 2.0.060 to the latest
April 20/2007 Version 2.00.065
--Changes from Version .060 to .065 are minor, soem GUI changes, and some changes specific to G100
interfaces. The Spindle delay function was updated however to allow for plugins to properly delay
prior to swiching off relays. Also the capability of using an L0 in a canned cycle was added , this
has the effect of making the prepretory move for the canned cycle, but not executing, however, the mode
is switched to the proper G8x mode for further commands to execute in the canned cycle mode.Also,
the program will now warn a user if a kernel speed change has occured and any motor is now set too
fast for that kernel speed.
May 1 2007 Version 2.00.068
Two new commands
M61P*********x sets the debounce interval to the value of P. Each count is approc 40us in debounce.
M60Pn This is a wait for OEMTrigger input. If M60P1 is used, then the system will stop
Processing Gcode lines until OEMTrigger#1 goes active. It is a simple trigger command, if the
OEMSignal1 is already active, then the line is ignore, but user is warned on status line of the
ignoring of the command
OEMLED#172 is now indicating if a file is loaded.
May 14 2007 Version 2.00.070
Bug fix in G81 where rapid was applied in G98 back up to clearance plane prior to the drill cycle.
Added Spindle input override to allow OEM DRO #39 to accept a spindle RPM from another device or macro.
This spindle speed may then be used in calibrations. OEM #39 cannot be sent input unless SpindleInputOverride
is enabled by Script call SetParam("RPMOverRide",1); From that poinit forward, OEM#39 may be used to set the true
spindle speed seen by the program.
Radius compensation repaired for slight offset in X axis during comp.
May 14 2007 Version 2.00.073
New selection in Config/general for "Home slave with Master. " , this selection turns off autosquaring
of a gantry and keeps the slave engaged during homing. Config/Toolpath "Use Origin sphere" also controls
display of the bounding box.
May 29th 2007 Version 2.00.075
Fixed two feedhold bugs found in Arc problems. Also, IsStill handling in G100.
June 18th 2007 Version 2.00.078
Added GetToolParam(SHORT toolnum, SHORT param) for tool parameters. Param numbers are 1 - n
and correspond to the tool window in the mill or turn modes. In turn for example, 1 is TipDia, 2 is Tip Radius..ect..
Repaired Protocol selection of Modbus protocols.
June 26th 2007 Version 2.00.080
G68 changes to display in DRO actual location on Gcode part. New shuttle plugin to incrementally jog in G68.
July 25th 2007 v2.03
Fucntional changes in Compensation.
Aug 1st 2007 V2.4 ( development update)
Fixes to Plugin variables with SDK. Fix to slave homing selection
Fix to debounce. Removed probe from debounce code.
Aug 2nd version 2.04
Added display of Radius comp in white on toolpath when loadin gprograms using G41/G42
Aug 7th Version 2.4
Rebuild of all current code changes from development side. Display of radius comp, plugin fixes etc.. into the
release and lockdown build. This version has been found to be very stable. Flash screen is one version behind end
version but is being rebuilt with multiple toolpath capability.