Just finished the control box on my Denford Novamill, it is 6 x 8 x 10 ins. My advice is to use a box at least twice the size you think you will need!!!
List of contents:-
3 Routout(UK) 2.5 amp stepper drivers.
CNC4PC C11G BOB.
24V 6Amp Power supply.
5V 2.5Amp Power supply.
Spindle motor Contactor.
E-stop relay.
Novolt release starter.
Big fan and filter.
The front panel was engraved with a 1.0 mm cutter using the Mach Write wizard.
Mounted on the back is the SMC-00 DC spindle motor controller from
www.beel.ca and an EMC Filter.
The numbers, which are 5mm high, were created in DesignCad using a vector font, exported as a DXF, then imported into Lazycam. I used a small pneumatic impact engraver resiliently mounted, to mark on the 45mm dia stainless steel tube. DesignCad has a plug-in, ContourCam, which I have yet to play with.
Still learning but the curve IS getting less steep.
Ian Ralston