Loaded Mach3 and post gcod or wizard and the code runs through but machine x,y, and z show no movement.

Hi,
what PC are you using?
What OS is loaded?
Are you using a parallel port?
If so post an image of DriverTest.exe results.
What breakout board and/or motion controller are you using?

Craig

Dell OptiPlex 760 using windows XP. Parallel port being used. The driver test showed "excellent" and the pulse rate was very steady at about 27,000.  I have yet to hook up my machine, but am not seeing any motion on the display DRO's. I remember from years ago that the display showed motion and the display actually showed the tool movement. I am not getting that now. Thanks for your reply.

Have you enabled your motors in Ports & Pins?

Hi,

Have you enabled your motors in Ports & Pins?

without motors being assigned, even if not connected then Mach will not display an axis movement.

Craig

OK  I will go through the entire setup process and see if that makes it work....fingers crossed.