Hello Guest it is October 20, 2019, 12:18:27 AM

Author Topic: 3 axis controller, custom build  (Read 586 times)

0 Members and 1 Guest are viewing this topic.

3 axis controller, custom build
« on: September 02, 2018, 09:31:32 PM »
Built controller box to run a custom CNC machine which has only ran for a few hours.  Cannot sell and ship complete machine so I am parting it out.

Enclose consists of the following:

110VAC power input
48VDC power supply (motor supply)
Additional 5/24VDC power supplies for home inputs and Dynomotion controller
Dynomotion KFlop/KAnalog controller
Gecko G203V Digital Step Drives x 3
Inputs for XYZ home proximity switches (24VDC)
Touch plate prewired
Dual relay outputs (configured for 110VAC loads, each with a 5 amp fuse)
External E-Stop
Four additional external buttons can configure/wire for run, pause, etc.

(Controller, Stepper drives and relay card are brand new)

500.00 + 80.00 (to cover UPS ground and shipping supplies + paypal fees)

Additional 100.00
Dell laptop running windows XP with Mach3 and Kmotion installed and configured to run above controller.  You will need to supply mach3 license.

I posted a picture of the complete machine just to give an idea.

Thanks!
« Last Edit: September 04, 2018, 01:34:27 AM by Tweakie.CNC »
Re: 3 axis controller, custom build
« Reply #1 on: September 03, 2018, 09:19:18 PM »
sold...thanks!