Machsupport Forum
Tangent Corner => Bargain Basement => Topic started by: gforce on September 02, 2018, 09:31:32 PM
-
Built controller box to run a custom CNC machine which has only ran for a few hours. Cannot sell and ship complete machine so I am parting it out.
Enclose consists of the following:
110VAC power input
48VDC power supply (motor supply)
Additional 5/24VDC power supplies for home inputs and Dynomotion controller
Dynomotion KFlop/KAnalog controller
Gecko G203V Digital Step Drives x 3
Inputs for XYZ home proximity switches (24VDC)
Touch plate prewired
Dual relay outputs (configured for 110VAC loads, each with a 5 amp fuse)
External E-Stop
Four additional external buttons can configure/wire for run, pause, etc.
(Controller, Stepper drives and relay card are brand new)
500.00 + 80.00 (to cover UPS ground and shipping supplies + paypal fees)
Additional 100.00
Dell laptop running windows XP with Mach3 and Kmotion installed and configured to run above controller. You will need to supply mach3 license.
I posted a picture of the complete machine just to give an idea.
Thanks!
-
sold...thanks!