Hello Guest it is December 07, 2024, 09:02:32 AM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Can't get mach 3 to drive the machine after re-load  (Read 3474 times)

0 Members and 1 Guest are viewing this topic.

Offline ger21

*
  • *
  • 6,295 6,295
    • The CNC Woodworker
Re: Can't get mach 3 to drive the machine after re-load
« Reply #10 on: July 31, 2018, 08:52:02 PM »
If the drivertest won't run, then Mach3 won't run.


Must be something on that PC causing it to not work.
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Pages: « 1 2   Go Up
« previous next »