Hello Guest it is November 15, 2019, 03:15:02 AM

Author Topic: Mach 3 Controlling Co2 Laser  (Read 755 times)

0 Members and 1 Guest are viewing this topic.

Mach 3 Controlling Co2 Laser
« on: June 10, 2018, 11:24:45 PM »
Hello Folks,

I am trying to do some etching/photo engraving with my co2 Laser, I currently am using a post that converts my g code to have m3 and m4 commands through v carve, I would like to be able to put a photo on a piece of wood, is this possible through mach? should i use a different program or maybe get a laser B.O.B, ? Here is some info on my setup below also have attached .tap file and photos of wiring let me know what you think i am currently only able to cut wood at what seems to be 100% power

Here is the link to my PSU


Here is a link to my BOB

« Last Edit: June 10, 2018, 11:27:00 PM by wes709 »

Online Tweakie.CNC

  • *
  •  7,995 7,995
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Mach 3 Controlling Co2 Laser
« Reply #1 on: June 11, 2018, 08:21:26 AM »
Hi Wes709,

The M3 / M4 commands are far too slow acting so the M10Px / M11Px commands were included within Mach3 (and the M63Px / M62Px within Mach4) specially for laser use.
This thread describes my exploits and may be of interest to you;   http://www.machsupport.com/forum/index.php/topic,12444.msg248511.html#msg248511

Although I have used Mach3 for laser reproducing photographic images for many years now, for me, the relatively new software Auggie seems to have taken over.

Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.