Hello Guest it is October 22, 2019, 03:42:00 PM

Author Topic: Post processor  (Read 1717 times)

0 Members and 1 Guest are viewing this topic.

Post processor
« on: July 20, 2007, 01:07:25 PM »
I'm using BobCad & Mach3 as the post processor. When I choose Mach3 it has no place to describe the tool I want to use, only a choice of tool 1 to tool 8. Is there a place in Mach3 to define the diameter of these tools?

Offline Chip

*
  • *
  •  2,056 2,056
  • Gainesville Florida USA
    • View Profile
Re: Post processor
« Reply #1 on: July 20, 2007, 02:40:58 PM »
Hi, Rkjohn

Look under Offset's Tab, Bottom right, Save Tool Offset's, There are 254 counting tool 0, No secondary Offsets though.

Hope this Helps, Chip
« Last Edit: July 20, 2007, 02:42:53 PM by afn09556 »