Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Rkjohn on July 20, 2007, 01:07:25 PM

Title: Post processor
Post by: Rkjohn on July 20, 2007, 01:07:25 PM

I'm using BobCad & Mach3 as the post processor. When I choose Mach3 it has no place to describe the tool I want to use, only a choice of tool 1 to tool 8. Is there a place in Mach3 to define the diameter of these tools?

Title: Re: Post processor
Post by: Chip on July 20, 2007, 02:40:58 PM

Hi, Rkjohn

Look under Offset's Tab, Bottom right, Save Tool Offset's, There are 254 counting tool 0, No secondary Offsets though.

Hope this Helps, Chip