hi all
i have a problem with g100, probably my mistake but if somebody can help will be nice
last lock down version mach3, with last version g100 plug in, last version firmware and fpga settings uploaded to g100,
then i set digital input 16 to be e-stop, and digital output 1 - spindle
look fine, spindle on-off-on-off no problems, then i press e-stop button ( digital input 16 connected to ground ), then release e-stop button, then with mouse i press reset button on the screen, mach3 is ready
after this i can run spindle only once, second time dwell light is on, to continue work i have to restart mach3 or g100