Wallerawang,
That is good news.
I have installed the Firmware in line with the instructions and it said it was successful.
I have tried the P1A-S Pendant on 3 setups.
1) Mill HiCON Controller with Mach4 V3481 - No Luck
2) Router ESS V220/V219V/216 with Mach4 V3481 and V3804 - No Luck
3) ESS V216 with Mach4 V3481/v3804 on our old controller with just a motor attached - No Luck.
Same E-STOP display at the start of Mach4 on both the Mill and Router 1), 2) and 3).
All these function with Mach4 but not with the VistaCNC Pendant.
There must be some conflict with E-Stop, but I tried turning then all off in Mach4 but still no luck.
Is it possible for you to send your mach4 configuration?
Regards,
Mauri.