Hi all
Quick intro, I'm new here and have a Denford Easimill converted to Mach 3 and micro stepping drivers.
Everything has been ok so far but last night I set up my home switches using the N/C contacts on 3 micro switches, all wired up and set the machine to home, it went the wrong way so I changed it back to home positive, my home is top right corner of the mill table.
Z axis moved up homed and off by the 3 mm as set, the same with the X & Y.
Now though if say I restart with the Z down any amount then try homing the Z moves up by a few mm and stops then the X & Y home properly, I can keep doing this until the Z actualy does hit the switch and then it all work correctly. Wierd.
Anyway I've tried setting it back up and also tried setting the home switches as + limits, and that doesn't work either, I just get a constant limit switch activated.
Is this something I'm doing wrong or is it a bug.
Mach 3 version 2.0.065.
Thanks
Steve