Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: poppabear on September 06, 2019, 08:53:16 AM
-
Does anyone have a "Firmware" (post processor) file for Simplify3D to Mach4?
Thanks in advance.
-
Hi poppabear,
if you have a post that produces good Gcode for Mach3 then it should work for Mach4 also.
I have encountered only one instance where code that runs on Mach3 fails under Mach4. Even then its
because Mach4 sticks more closely to ANSI Gcode.
Craig
-
Hi Joe,
Thanks, but not really what I am asking/looking for, I need a "Simplify3D" Post processor (firmware file),
for the CAM software for out put to Mach4. I am very familiar with both mach3 & 4 as far as
what and how they run. I was/am hoping some one has the post so I do not have to recreate it,
since it is a PIA.
-
Hi,
so you don't have a Simplify3D post for Mach3 either?
Craig