It is connected with soft limits - turn them
OFF and you
can do a simple, single axis G31 routine.
Try and do a two-axis and on the second axis G31 you get a “probe ignored” error and it fails.
Absolutely broken I think, not only is it linked to soft limits for an unknown reason, it crashes if you try more than one axis.
So, clearly its not going to play, I have been reading a
lot today and theres historic ‘net content stating G31 and M31 are broken on all but a few setups - needs version 022 of Mach which i cant use as my screen set fails on it - too old, there is a lot of non-probing people out there
A few have ditched CSLABS kit and gone UC300eth etc
A few have ditched due to poor/rude customer support
I just don’t know now, what to do, I have a probe i cant use, an unreliable setup and so on - any suggestions??