Thanks for your replies
Hi,where did you buy the UC100? Did you have to install software for the USB link?
Do you have the UC100 plugged in to a breakout board?
Craig
Bought from a trusted seller it is genuine. Not plugged into the Ghecko yet, just trying to test for now. I downloaded the newest driver and software from cncdrive and installed according to thier instructions.
What version of Mach3 are you using? You might want to try a different version.
Those messages are coming from Mach3, not the UC100 plugin, which is why CNC Drive said it was a Mach3 issue.
Since Mach3 is not supported at all, you're not likely to get an answer from anyone. I've never heard of this error before.
Version R3.043.066 of Mach3, I hope I can solve it because I do want to use Mach3 (with one of your skins) very nice work. I have 100's of skinning hours with an older recording program.
This same issue has occurred on 2 different computers. Installs were made both through cncdrive installer and individually installed with individual components..
Thanks again, please don't give up on me and continue to think about possible causes.