Hi,
Hmmm, I think there was a checkbox to include the wizards, or not, at the install/setup.
Might be wrong tho.
Not that I could find, I recall seeing that in Mach3 but not Mach4.
Have you checked the configuration to see if the axis have motors enabled and those motors are mapped to the axis? It won't jog if the axis do not have enabled motors mapped to them.
The Mach4Lathe profile that ships with Mach has motors enabled and sensible numbers for motor tuning and so on, my expectation is that it would load and run with
the Sim(ulator) plugin out of the box. Indeed when Mach4Lathe has loaded completely and successfully it runs in Sim mode just fine.
I was re-reading Russ's thread and Mike had a suggestion that you make a new profile with the lathe.set but I presume that has no canned cycle modules.....could then
add them one at a time until I find a fault.
Craig