No luck with .062
It might have something to do with offsets some how.
Latest testrun was like this. Without the "Rot 360 rollover" or the "And Short Rot on G0" ticked in.
Started Mach3 0.62 with all new profile with new settings.
Made 2 succesful runs of code.
Third attempt stalled A axis at first attempt to rotate 60 degrees. It got to something like 39.2343 degrees and then halted. Readouts in mach3 showed that halted position and it did not change but Mach3 kept following the code, drilling "new" holes but stuck in the same degrees.
It even read this "N200 G91 A60 F1500 (**Go Next Incremental Angle**)" and kept going after that even though the A axis didnt move.
I stopped the program and rewinded it. Then manualy jogged the A axis back to 0 and tried again with the same result.
It starts to move from A0 towards A60 but this time after A39.2343 it jumped directly to something like A-5236.3425.
I can jog back and forth and the jump keeps happening very accuratly.
Stumped!
Any suggestions?