Hi, I'm just setting up my plasma cutter table.

It would be very helpful to be able to change the jogging speed of the torch so I can slow it right down sometimes. (With the torch firing I could cut off the thin waste pieces 'manually' - that is, without having to generate a bit of code.)

I presume this is done all the time but I'm new to Mach and I haven't found a way to set the speed.

Please can you help?

Thanks,

Tim

Hi Tim,
I you hit the tab key a flyout will appear and then you can adjust the jog percentage in the jog DRO IIRC.

Mike

Thanks, Mike. I don't know how I missed it!

Glad I could help.
It took me awhile to find it the first time I used Mach 3.
Mike