Machsupport Forum
Mach Discussion => Mach3 under Vista => Topic started by: Tim Rowe on January 14, 2018, 11:37:48 AM
-
Hi, I'm just setting up my plasma cutter table.
It would be very helpful to be able to change the jogging speed of the torch so I can slow it right down sometimes. (With the torch firing I could cut off the thin waste pieces 'manually' - that is, without having to generate a bit of code.)
I presume this is done all the time but I'm new to Mach and I haven't found a way to set the speed.
Please can you help?
Thanks,
Tim
-
Hi Tim,
I you hit the tab key a flyout will appear and then you can adjust the jog percentage in the jog DRO IIRC.
Mike
-
Thanks, Mike. I don't know how I missed it!
-
Glad I could help.
It took me awhile to find it the first time I used Mach 3.
Mike