I'm trying to convert a simple DXF into Gcode and it seems to only want to write 50 lines of code. I'm not sure if it's crashing out and failing to write the file or if Is this a deliberate thing?
The job is 4 layers - Holes, inside, slots and outside. There are only 2 chains on the inside (cut second). It finishes the first chain and then has a few G40's and G42's and that's it. Seems a little weird so at the moment i'm seeing it as a bug and not a feature.
This same DXF worked ok on previous versions of LC ok.
I can post the DXF if you like.