Hello Guest it is July 06, 2020, 06:14:53 AM

Author Topic: Mach Not loading G Code?  (Read 856 times)

0 Members and 1 Guest are viewing this topic.

Mach Not loading G Code?
« on: December 13, 2017, 08:56:08 PM »
Hello Folk...

New to forum.  And serious new guy question here.  (I did search for a good time before asking this)

My G Code is not loading into Mach.  This is a new development.  Been following the original procedures for almost 3 years.  Lots of code run thru my machine.

It appears to load up a default set of parameters but nothing looking like anything I have seen before.

I thought it was my latest program.  So I did some trouble shooting and loaded an older file that I have used many times a month.  Same result.

Any thought would be super appreciated.... 

Attached photo of the text loaded into the code box.

Offline ger21

*
  • *
  •  6,281 6,281
    • View Profile
    • The CNC Woodworker
Re: Mach Not loading G Code?
« Reply #1 on: December 13, 2017, 09:10:04 PM »
Not sure what that is, but it's not g-code.
Where did this file come from?
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html