Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Brew Worx on December 13, 2017, 08:56:08 PM
-
Hello Folk...
New to forum. And serious new guy question here. (I did search for a good time before asking this)
My G Code is not loading into Mach. This is a new development. Been following the original procedures for almost 3 years. Lots of code run thru my machine.
It appears to load up a default set of parameters but nothing looking like anything I have seen before.
I thought it was my latest program. So I did some trouble shooting and loaded an older file that I have used many times a month. Same result.
Any thought would be super appreciated....
Attached photo of the text loaded into the code box.
-
Not sure what that is, but it's not g-code.
Where did this file come from?