Hello Guest it is March 29, 2024, 05:31:49 AM

Author Topic: Spindle analog signal  (Read 5342 times)

0 Members and 1 Guest are viewing this topic.

Spindle analog signal
« on: December 12, 2017, 10:00:28 PM »
Having a mental lapse.

Hard drive crashed. Rebuild system but I cannot remember how I get the analog output to work for the spindle drive.

Spindle type - Analog (0-10v)
Spindle index - 7
Spindle scale - 100%

Using analog output 7 - Analog I/O port - J2 pin 19 and pin 17 (GND)

I get no voltage output from these pins.

What did I miss?

Thanks.
Re: Spindle analog signal
« Reply #1 on: December 13, 2017, 01:20:00 AM »
What is the plug-in and dspmc firmware version in your system?
Re: Spindle analog signal
« Reply #2 on: December 13, 2017, 08:54:54 AM »
Plug-in 2.01.72
Firmware 10.10 FPGA E901
Re: Spindle analog signal
« Reply #3 on: December 13, 2017, 11:27:36 AM »
please email the profile to support@vital... and we will check it.  go to mach4 help menu and select package current profile and email it. 
Re: Spindle analog signal
« Reply #4 on: December 13, 2017, 02:08:24 PM »
We found that the M3/M4/M5 macros in your profile were corrupt.   once they were deleted from the macros folder, the spindle analog voltage started working.