Machsupport Forum

Third party software and hardware support forums. => dspMC/IP Motion Controller => Topic started by: lcs226 on December 12, 2017, 10:00:28 PM

Title: Spindle analog signal
Post by: lcs226 on December 12, 2017, 10:00:28 PM

Having a mental lapse.

Hard drive crashed. Rebuild system but I cannot remember how I get the analog output to work for the spindle drive.

Spindle type - Analog (0-10v)
Spindle index - 7
Spindle scale - 100%

Using analog output 7 - Analog I/O port - J2 pin 19 and pin 17 (GND)

I get no voltage output from these pins.

What did I miss?

Thanks.

Title: Re: Spindle analog signal
Post by: Vital System Support on December 13, 2017, 01:20:00 AM

What is the plug-in and dspmc firmware version in your system?

Title: Re: Spindle analog signal
Post by: lcs226 on December 13, 2017, 08:54:54 AM

Plug-in 2.01.72
Firmware 10.10 FPGA E901

Title: Re: Spindle analog signal
Post by: Vital System Support on December 13, 2017, 11:27:36 AM

please email the profile to support@vital... and we will check it.  go to mach4 help menu and select package current profile and email it. 

Title: Re: Spindle analog signal
Post by: Vital System Support on December 13, 2017, 02:08:24 PM

We found that the M3/M4/M5 macros in your profile were corrupt.   once they were deleted from the macros folder, the spindle analog voltage started working.