Hello Guest it is November 15, 2019, 06:17:34 PM

Author Topic: Mach 4 not creating square inside corners  (Read 621 times)

0 Members and 1 Guest are viewing this topic.

Mach 4 not creating square inside corners
« on: December 12, 2017, 01:31:06 PM »
Hello,
I am not sure where this problem is occurring. I know it's not a lost step issue because I zero precisely back to start after I cut. See the attached pic for the problem, basically, on an inside pass on a 90degree angle half of my corners are swept strangely. Is it a misunderstanding of ramping? I have tried with ramping on and off with the same results.
Re: Mach 4 not creating square inside corners
« Reply #1 on: December 12, 2017, 03:15:06 PM »
Hi,
that is an example of low acceleration when operating in CV mode. Try switching to exact stop mode to confirm
it.

It may then be neccessary to revisit the CV and acceleration settings.

Craig
My wife left with my best friend...
     and I miss him!