Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: makemasters on December 12, 2017, 01:31:06 PM

Title: Mach 4 not creating square inside corners
Post by: makemasters on December 12, 2017, 01:31:06 PM

Hello,
I am not sure where this problem is occurring. I know it's not a lost step issue because I zero precisely back to start after I cut. See the attached pic for the problem, basically, on an inside pass on a 90degree angle half of my corners are swept strangely. Is it a misunderstanding of ramping? I have tried with ramping on and off with the same results.

Title: Re: Mach 4 not creating square inside corners
Post by: joeaverage on December 12, 2017, 03:15:06 PM

Hi,
that is an example of low acceleration when operating in CV mode. Try switching to exact stop mode to confirm
it.

It may then be neccessary to revisit the CV and acceleration settings.

Craig