Hi All:
Need a bit of help.
I designed a screen that I've been using for a while now. I decided to move some things around and rearrange a bit. Saved the new screen as a different name. Then, I started Mach3 and loaded the new screen. However, I have noticed that the hot keys for jogging x,y&z don't work anymore. I've looked at the config. from the main menu and even reset the hotkeys that control axis jog. Still no movement.
I'm lost. Anything come to mind that I may have hosed? I did load the old screen and the hotkeys work fine. Back to the new screen and they don't work.
Help is appreciated.
Thanks
LEW

These are the first two things I think of other than the slow jog rate being set to 0.

Brett

Thanks for the reply, Brett.
I did a bit more moving things around. Wound up moving some of the buttons from the persistent screen to screen one. Then I saved everything again and now the jog hot keys work again. Not sure what it was that caused the problem but I'm good for now.
LEW

Your welcome Lew, glad you got it sorted.

Brett