Hello Guest it is March 28, 2024, 06:15:29 AM

Author Topic: stuck on external estop  (Read 3358 times)

0 Members and 1 Guest are viewing this topic.

Offline ticoe

*
  •  12 12
    • View Profile
stuck on external estop
« on: June 30, 2007, 03:56:13 PM »
i just purchased digital Rockcliff cnc machine plans over the net and the Mach3  software was included. Iam totaly new at cnc software and working  with it to get to know it, nothing seems to work . its constantly asking for an external Estop on the bottom left hand corner.?
I have no hardware hooked up, and the reset botton is useless?   somebody help me.
also looking to start building a small cnc router and help selecting hardware would be appreciated.

thanks ticoe
Re: stuck on external estop
« Reply #1 on: June 30, 2007, 04:00:38 PM »
Go to the diagnostics tab and see if any inputs (little red lights on the right of the screen) are on.

Offline Greolt

*
  •  956 956
    • View Profile
Re: stuck on external estop
« Reply #2 on: June 30, 2007, 06:26:24 PM »
As you have no hardware hooked up,

Go to,  Config / Ports and Pins / Input Signals and scroll down to Estop and toggle the Active low setting.

After that go to the following link,

http://www.artsoftcontrols.com/artsoft/videos.htm

Watch at least these videos, "Downloading and Installing", "Hooking up Inputs and Outputs",  "Screens - An Overview" and "Coordinates / Homing"

Greg
« Last Edit: June 30, 2007, 06:30:47 PM by Greolt »