Hi
I have an issue. My cnc lathe has an 8 tool ACT. The tool table is set with tool no 1 as the master.
Normally every thing works perfect when canging tools but; i run the Mach 3 wizzard, save, post the code and run the code. Evrything is ok. Than I go back and do som changes in the wizzard , save, post code and than the tool setting is completly wrong. No toolchange has been done. Same tool in the DRO as well.
Than I restart the PC, set master tool and every thing is ok again.
Sent from my iPad using Tapatalk