Hello Guest it is October 23, 2019, 12:21:24 PM

Author Topic: Hows That Beer Flight Looking  (Read 6040 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  7,958 7,958
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Hows That Beer Flight Looking
« Reply #10 on: October 02, 2017, 03:42:21 AM »
Have you sorted out you Y axis and made this yet ?

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline Daner

*
  •  32 32
    • View Profile
Re: Hows That Beer Flight Looking
« Reply #11 on: October 02, 2017, 08:41:54 AM »
Hi Tweakie,
My Y is not too accurate but it is getting me by.
I'm practising making a few signs, and asking as I don't expect fine details it will have to do.

Yes I ran the 2 nd file you sent and the pockets we way off. Ie the pockets drifted off more than 1 inch.
I'm using vcarve pro soon at the stage of learning how to create  round pockets inside a vector

I'm not set up with a cut through spoil board at this time so if I could just start with just cutting out 3 pocket holes
That will be a start for me.

I'm still having fun though

Offline Daner

*
  •  32 32
    • View Profile
Re: Hows That Beer Flight Looking
« Reply #12 on: October 02, 2017, 08:22:44 PM »
Im going to try this one tomorrow ;D
Any one else with a Beer board ?

Offline Tweakie.CNC

*
  • *
  •  7,958 7,958
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Hows That Beer Flight Looking
« Reply #13 on: October 03, 2017, 04:33:48 AM »
That's the way to go - start simple and progress from there.

(Routing circular pockets can place quite a lot of stress on a machine and it is likely to show up any weaknesses which can then be dealt with accordingly).

Tweakie.


I drink my beer 'out of the can' - never have time to stand it down and look at it  ;D
« Last Edit: October 03, 2017, 04:35:38 AM by Tweakie.CNC »
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.