Hello Guest it is August 20, 2019, 05:31:20 PM

Author Topic: Mach3R2.0.079 Gen-Con-Fig. "Active Plane of View" XY YZ XZ  (Read 2163 times)

0 Members and 1 Guest are viewing this topic.

Offline Chip

*
  • *
  •  2,056 2,056
  • Gainesville Florida USA
    • View Profile
Hi, Art

Using Gen-Con-Fig. Active Plane of View XZ or YZ doesn't change view, View stays in XY, Also YZ view doesn't show Arc's properly,

Picture below shows YZ view with arc problem, Would be nice if Active Plane of View was displayed/shown on View screen somewhere.

See Att. .tap file used.

Hoop-ping it's Me not The

Thanks, Chip

Offline Chip

*
  • *
  •  2,056 2,056
  • Gainesville Florida USA
    • View Profile
Re: Mach3R2.0.079 Gen-Con-Fig. "Active Plane of View" XY YZ XZ
« Reply #1 on: June 26, 2007, 11:17:01 AM »
Hi, Art

Sad to see that, Guess I missed it, Could you remove it from General Config Screen as an option.

 Then you'll not have this Pop-Up as a topic any more.

There is still a problem in XY View of arcs though.

It's drawn properly if the XZ is used, Even though the view is XY. ?

Thanks, Chip