Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Chip on June 26, 2007, 10:00:06 AM

Title: Mach3R2.0.079 Gen-Con-Fig. "Active Plane of View" XY YZ XZ
Post by: Chip on June 26, 2007, 10:00:06 AM

Hi, Art

Using Gen-Con-Fig. Active Plane of View XZ or YZ doesn't change view, View stays in XY, Also YZ view doesn't show Arc's properly,

Picture below shows YZ view with arc problem, Would be nice if Active Plane of View was displayed/shown on View screen somewhere.

See Att. .tap file used.

Hoop-ping it's Me not The

Thanks, Chip

Title: Re: Mach3R2.0.079 Gen-Con-Fig. "Active Plane of View" XY YZ XZ
Post by: Chip on June 26, 2007, 11:17:01 AM

Hi, Art

Sad to see that, Guess I missed it, Could you remove it from General Config Screen as an option.

 Then you'll not have this Pop-Up as a topic any more.

There is still a problem in XY View of arcs though.

It's drawn properly if the XZ is used, Even though the view is XY. ?

Thanks, Chip