Hello Guest it is May 10, 2021, 10:00:16 PM

Author Topic: Mach4 Tangential  (Read 1328 times)

0 Members and 1 Guest are viewing this topic.

Mach4 Tangential
« on: July 27, 2017, 07:10:02 AM »
Any word on when this will happen? Without tangential I can't use it on the systems I build.

Offline smurph

*
  • *
  •  1,400 1,400
  • "That there... that's an RV."
    • View Profile
Re: Mach4 Tangential
« Reply #1 on: July 27, 2017, 10:14:29 PM »
Have you tried it?  Tangential is a choice in the config dialog. 

Steve
Re: Mach4 Tangential
« Reply #2 on: August 23, 2017, 03:28:57 PM »
I do not see Tagential as a option is Mach 4. Is it there somewhere and I am missing it?
Re: Mach4 Tangential
« Reply #3 on: August 23, 2017, 03:50:31 PM »
Look on the Config > Mach page under the General tab. There is a selection
area on the left side called "Control Mode" and you will find tangential in the
drop down selections.

Steve Stallings
www.PMDX.com
Steve Stallings
www.PMDX.com
For PMDX product support, please use PMDX forum or direct email for quickest response. We do not use this forum as our primary product support site.